The issue is I am not getting any signal to the light strand. I am using known good cables, known working USB Dongle, and known working uSC controller. When I output signal to the setup I can see that the USB Dongle is getting signal but nothing happens through the Hub. It is powered and when the light strand is plugged in I can trip the magnetic test strip on the uSC and the lights sequence through the test, so I have power to the lights. I have meticulously followed and rechecked the cables to make sure the signal path is correct and thus far I see no problems there.
What could be causing the Hub to not allow the signal through? The PIC is programmed and verified also.
I thought initially, "well this must be an issue with this Hub". So, I pulled out my second Hub and the same thing...nothing happens. I just built both of the boards about a month ago and again, I double checked that everything was in its proper place and soldered correctly according the the Wiki instructions. Both Pixelnet jumpers are set to position 1 and the DMX jumper is set to position 1. I am at a loss here and don't know where to go from here. Can anyone help me troubleshoot these Hubs?