Author Topic: PROGRAM multiple controllers at once? (Read 1099 times)

urthegman · « **on:** December 10, 2012, »

If I have four SSC's that all use the same channel numbers. Can I hook all 4 up to an active hub and flash them all at the same time?

PJNMCT · « **Reply #1 on:** December 10, 2012, »

urthegman · « **Reply #2 on:** December 10, 2012, »

Thanks!!! That just made this mornings activities a LOT easier!!!!

sjb · « **Reply #3 on:** December 10, 2012, »

I am not sure, are you asking if you can use the ICSP header on the hub to flash the SCC's?

urthegman · « **Reply #4 on:** December 10, 2012, »

Nope, to assign channel #'s to the SSC's.

jnealand · « **Reply #5 on:** December 10, 2012, »

If we would all use "Flash" for firmware and "program" for channel numbers that would help. We all seem to confuse the two terms. Mark me guilty as well.

urthegman · « **Reply #6 on:** December 10, 2012, »

I'll try, my brain is racing so fast this time of year, sometimes I have a hard time getting the words out!!!! Please note the change of title!!!!

PJNMCT · « **Reply #7 on:** December 10, 2012, »

Yes, I was answering the original title "program" not the changed "flash".

DiyLightAnimation

News:

Author Topic: PROGRAM multiple controllers at once? (Read 1099 times)

urthegman

PROGRAM multiple controllers at once?

PJNMCT

Re: Flash multiple controllers at once?

urthegman

Re: Flash multiple controllers at once?

sjb

Re: Flash multiple controllers at once?

urthegman

Re: Flash multiple controllers at once?

jnealand

Re: Flash multiple controllers at once?

urthegman

Re: Program multiple controllers at once?

PJNMCT

Re: PROGRAM multiple controllers at once?