DiyLightAnimation

Hardware => Lynx EtherDongle => Topic started by: Mickpat on May 11, 2013,

Title: Use Etherdongle with conductor daughterboard connected
Post by: Mickpat on May 11, 2013,

Can I reflash my Etherdongle with a conductor attached to it back to the original etherdongle mode without disconnecting the daughterboard?  I would like to do some testing of E1.31 output using LSP and don't want to disconnect the daughterboard.  Its so hard to take off and I don't want to damage it.

Title: Re: Use Etherdongle with conductor daughterboard connected
Post by: dcwehw99 on May 11, 2013,

Yes, you can.

Denny

Title: Re: Use Etherdongle with conductor daughterboard connected
Post by: Mickpat on May 11, 2013,

Excellent.  Thank you.

Title: Re: Use Etherdongle with conductor daughterboard connected
Post by: keitha43 on May 11, 2013,

Yes I did that and was able to test to see if the display was wired up correctly. So I keep one with conductor firmware and one with etherdongle firmware.