DiyLightAnimation
Hardware => Lynx Smart String => Topic started by: jwilliams31 on November 02, 2018,
-
I bought a bunch of pixels off of Amazon, and I noticed that they seem to be using 4 wires. Two for power and (I'm assuming) two for data. Since the controller is only designed for a 3 wire, any thoughts on how this might be wired?
I've attached a screen shot from the Amazon picture. I'll try to get a better picture from the actual pixels when I get home.
Thanks.
-
Never mind. I looked at the specs for the lights online and found what the wire colors are:
Connection: Red: +12V; White: DATA; Blue: GND
So apparently the ground (Blue) is just split between the two connectors, so I should just need to splice them together into the 3-wire connector.
-
Glad you found the answer!
It might help if you provide the link to the Amazon page and especially the documentation for the product you bought.
Thank you,
:) joe
I bought a bunch of pixels off of Amazon, and I noticed that they seem to be using 4 wires. Two for power and (I'm assuming) two for data. Since the controller is only designed for a 3 wire, any thoughts on how this might be wired?
I've attached a screen shot from the Amazon picture. I'll try to get a better picture from the actual pixels when I get home.
Thanks.