DiyLightAnimation
Hardware => Lynx Express => Topic started by: salongaopm on March 30, 2010,
-
Hi!
I have just finished my first LE. Five more to go. Just want to post pictures and get some feedback weather I need to add more solder or remove some before I start working on the second LE. Any feedback will be greatly appreciated.
Thanks again!
-
To me, the amount of solder looks good. It might be good to have a *little* more on a few of them (where the solder is drawn-down flush with the board surface), but overall, to me, it looks really good!
--Dave
-
It looks a whole lot better than my first one.
Each one will be exponentially better.
You didn't say if it passed the tests and is working.
John
-
It looked excellent to me.
Be sure you don't linger on the pads too long.
-
Good looking controller if you ask me!
<la..
RJ
-
Thank you for all the replies.
It might be good to have a *little* more on a few of them (where the solder is drawn-down flush with the board surface), but overall, to me, it looks really good!
--Dave
Ok, I will look at again and add more.
You didn't say if it passed the tests and is working.
John
It did pass the test as shown on picture #2. The first chip didn't work so I have to replace it with another one from my other set.
Be sure you don't linger on the pads too long.
I have to crank up the temp to 350 because it is taking too long for the solder to melt and adhere. I need to work more on my soldering technique.
A Texas size THANKS to you RJ for all your hard work. You made it alot easier for all of us especially to a newbie like me. The video manual was exceptionally helpful.
Again, thank you!