Hi Frank,
Just loaded up the converted “You are a Pirate†sequence into xlights
All the flexstrips are running perfectly (there’s 14 main flexstrips and 8 pumpkin flexstrips), no lag, no delay, just perfect.
There’s about 5000 channels I’m running through the xlights scheduler
The CPU utilization is so low, it doesn’t even register a % (couldn’t believe it at first, had to check a couple of times to make sure)
Memory utilization is ridiculously low at 49MBytes, again barely registering.
Now I also have two 512 DMX channels broken out on the two Hubs (512 channels of DMX on each hub), one of them that
is running the Pumpkin singer is delayed so the singing isn’t in sync, at first I thought it was because they are LED lights
that I used to replace a 100 count incandescent string. So I loaded it with a few incandescent C9’s to bring up the load
a bit. Didn’t work though, still had lag. I need to do some more digging on that issue.
I didn’t do a long term test, just ran it for 30 mins, but its awesome, just awesome.
Your conversion works 1st time right off the bat, I’m in awe
I’m going to drop another sequence into the drop box in a moment (it’s the most complex sequence I have), after the conversion
I’ll run it in xlights and see what happens.