DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: fyb2000 on December 11, 2012,

Title: is it possible to use the smart string utility with the conductor firmware?
Post by: fyb2000 on December 11, 2012,

Haven't tried it myself, as the conductor is not mine, and I do not want to damage it in any way. Opening it and changing firmware (removing it from the case...) is not something I want to risk, but I had one SSC going bad on me last night, and I need to program a spare. I am just not sure if the conductor firmware on the etherdongle would allow the communication through.

Title: Re: is it possible to use the smart string utility with the conductor firmware?
Post by: rrowan on December 11, 2012,

The conductor won't pass the info from the SS Utility

You have to reflash the firmware on the etherdongle back to its firmware. You don't have to remove the conductor when you change the firmware and then update your SSC. When done you can put the conductor firmware back in.

Rick R.

Title: Re: is it possible to use the smart string utility with the conductor firmware?
Post by: fyb2000 on December 11, 2012,

I will just build a new etherdongle (I have a spare not built yet) or use a USB dongle.
The case the etherdongle/conductor is in, has no opening to get the pickit attached. So I would have to unscrew it (audio jack, board...) to get access to the programming pins. It's not mine, I just don't want my fingers go crazy with someone else belonging (my fingers are deadly, there is a picture of what they can achieve in another thread, in 'the porch')