I have a EtherDongle that programs with no problem but I can't get it to work. I'm not sure but I may have had it hooked up to a Zeus 8 that I had the 7805 and LD1117c interchanged which fried the 7805 for sure. I replaced both and the Zeus 8 works fine now. If I had this board hooked up at the time, I don't think I did, could it have sent power down the Pixelnet In port to the MagJack?
Green Light on the EtherDongle Lights up.
MagJack green light usually will light up solid with the cable plugged in.
MagJack yellow light comes on solid for a few seconds with the cable plugged in then goes out.
The cabling work because I can unplug it and use it with a different EtherDongle and it is fine. I checked all the solder points with a low power stereo microscope and they looked good. I retouched up just in case although I was pretty sure it wouldn't make a difference. I swapped the 6n137's and the st485bn's with the other dongle with no help. The other dongle still works. Any thoughts on this one? I'm figuring I am gonna have to start replacing parts, I'm just not sure which ones to start with.
Jerome