Hi Sean,
I wanted to create a effect and I am not sure how to go about it.
Its a single strand RGB window so 4 sides of 48 nodes total. I wanted to have the nodes off and then start at the bottom and move up a fade in to red then once all red it does the opposite with the nodes going white and then repeat.
So the bottom starts off red and then the nodes on the left and right side come on then then the top comes on to red.
Then at the top (a few seconds like) a smooth shift to white and then the white moves down the sides to the bottom.
A pause then fade to black and then repeat.
I would like it slow and smooth since its just a effect with no music.
Using Vixen 2.1
Any ideas how to do that?
Thanks
Rick R.
so
Phase 1, bottom goes from black to full on red. This is like a color wash, no movement just fade from black to red
phase2, leave bottom full red and fade in both sides to full red.
OR
do a single chase from the bottom to the top with a RED
Phase3, after sides are full RED, fade in top to FULL RED
Phase 4, some amount of secondss, like 5-10, nothing happens. Window frame is FULL RED at this moment
Phase 5, fade RED on top to WHITE
Phade 6, fades sides from RED to WHITE
Phase 7, fade bottom from RED to WHITE
did i get it right??
sean