DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: taybrynn on December 20, 2013,
-
I have a pickit3 for a couple more hours -- is there any way to do a quickie flash without building out the whole board first?
I installed the ISPF header and was wondering if anyone knew what the minimum would be to flash the PIC or if thats even advisable at all.
THanks,
Scott
-
Probably too slow on the response, but it would try it with just the header. You might need a capacitor and/or a resistor or two. Since the pickit provides power to the pic, the programming circuit is usually very simple.
-
one of the small caps near the pic is required.
RJ