DiyLightAnimation
Hardware => Lynx Express => Topic started by: fertsy on November 26, 2010,
-
My express seems to have lost its DMX single. Worked fine yesterday and nothing today. Test seems fine with the exception of the end where the DMX light is not lit. I changed USB and Ethernet cords. I tried RJ's start program and it seems to find the dongle but no communication to the board as far as I can tell. I restarted the computer several times and the express. No luck...
Any ideas?
-
I reset the power on all my controllers today and after that one LE didn't work. I hit the reset and everything took off.
Is the last unit in your network terminated?
-
I only have one unit, and no its not terminated. It was like that the day I got it and I have not changed It....
Where is the reset mine is vs 3 does it have one?
-
The last device in the chain must be terminated. This may or may not solve your issue, but dmx requires termination.
Cheers,
Egenoup.
-
Well it worked fine yesterday... I will go terminate it and reset everything and try again... I am on teamspeak if anyone is available for a little help.
Thanks,
Joe
-
The reset didn't appear until V5 that I know of. Unplugging it (cycling power) is the only way then.
-
RJ was able to help me trouble shoot. It appears that my Flux Capacitor went bad (aka XO Oscillators 40MHz 5V)
Apparently I won some kind of reward as this has never happened to anyone else.
Thanks again RJ for the help. Ill let you know when its back up and running.