DiyLightAnimation
Hardware => Lynx Express => Topic started by: jwilliams31 on October 23, 2011,
-
While running test mode, my channel 15 will not light. I checked voltage across the led from pin 2 on the 3023 to the pic and I'm seeing 2.6 volts, so I know my solders are good.
Here's the thing, all of the other LEDs show about 1.9 volts. Why is this one higher.
Do I just have a bad led.
Thanks.
Jason
-
Greetings,,,
Check if the diode is in backwards.
Keith
-
That was it. I have no idea how I managed to do one out of the 16 diodes backwards.
Thanks for the tip.
Jason