DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: mmais68569 on May 31, 2011,
-
I do not see it in the BOM but can the MR 16 be run wireless with RJ's units? Does the receiver solder direct to the PCB?
Mike
-
Yes they can be wireless,
http://diylightanimation.com/wiki/index.php?title=Mod_Wireless
-
based on the 2 reply's the EX receiver DOES NOT connect direct to the board.
I have looked at the WIKI & am not very sure how this will work Does the 535-08-600-10 replace the replace the RS485 chip or do I need to solder this in place of the RS485 & then replace the chip on top. This is a learning year for this old man I am converting over from LOR so sorry for all the questions.
Mike
-
Hi Mike,
There is a header that is required. You then solder the wires (RC controller wires off of Ebay, RJ recommended and they work great) to the header and to the EX/RX board in the holes shown in the picture, and your ready to go, have fun,
Bill
-
You unplug the chip and remove it and then plug the header in place of the chip.
RJ
-
Thanks RJ
That is the simple answer I was looking for.
Mike
-
What if I used a TX/RX wireless placed in a case & ran a Cat 5 cable from it to the MR 16 will that work?
Mike
-
What if I used a TX/RX wireless placed in a case & ran a Cat 5 cable from it to the MR 16 will that work?
Mike
Yes, as long as the TX/RX is in RX mode :)
Rick R.
-
Thanks Rick