DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: Nightowlz1966 on April 09, 2012,
-
Hey Everyone
I bought a MR-16 to be my first board ever to try to build as the price was right LOL...
I know the instructions are out of date and looking at my board there appears to be places for 20 resistors
but I have 22 resistors in my kits .... Are all the resistors the same rating or are my eyes playing tricks on me.
I know 16 of them should be the same but what about the others.
Thanks
Brian F
-
Sorry you are having problems. The manual should be updated soon, which does not help you at the moment.
If you have a multi-meter then I would use that to read the value of resistance of each resistor and then put them on the board according to the markings on the board.
Rick R.
-
The V2 Board only has a total of 20 Resistors, So if you are sure they are all the same then you must have been sent to many. you should have 16 that have 1 orance stripe on them plus some other colors (3K ohm), put those aside. Then you should have 4 remaining. 2 that are the same(100 ohm), 1 that has a hard to see yellow next to the leg (4.7K phm), the last one has a gray strip on 1 of the 2 inner bands the (180 ohm). Hope this helps.
-
Thanks Guys Maybe I can get it figured out this evening.
The capacitors nor the resistors have a polarity issue do they ?
-
We built one last week. The colors on the resistors were very close in color codes, so watch out. Had to take three pieces off and redo.
-
... The capacitors nor the resistors have a polarity issue do they ?
Only the 100 uF Cap has polarity.