Great improvement RJ,
Pretty cool about the pads and the 47K resistors, that was in my wish list.
About remove the chip I also had some troubles to remove the Pic. When I finished my boards I plugged and they did not boot, didn’t know if the Pic was bad or was not programmed properly, I ran several iterations changing several Pics and reprogramming them until the 3.3V led turned on, was not sure what the problem was since the board boot with some Pics and not with others, was not really too hard to remove the Pic but it can take some time and some legs can be a little bended since the angle to access to the bottom of the PIC is large, especially after the board is assembled.
Programming the Pic on the board is a great feature, but could be nice to leave a small open space on the top of Pic to easy removal, especially for troubleshooting.
I’ll be ordering several of them when the co-op is open.
Gus.