Hardware > Panther DMX Player
I'm having a problem
Beanbag109:
I just finished my V2 board last night. I plugged in 12v power, and nothing (no lights). Well the voltage regulator started to heat up quick and hot (heat sink is installed),so I unplugged it. I was in full OCD mode while soldering. All solder joints look great.
Where/what should I do to start to solve this?
Thanks for any advice
Mike
rmp2917:
Make sure the voltage regulator is not installed backwards and that nothing is shorted.
Post some pictures of both sides of the board.
Beanbag109:
I'll post pictures when I get home. I installed the VR just like the pucture showed in the bulid instructions.
TexasStingray:
At 12 volts it will get warm but it should not get hot. Please post good quality pictures when you can.
Beanbag109:
third try to upload
Navigation
[0] Message Index
[#] Next page
Go to full version