I'm adding some more legs to my tree and I'm fighting a string and not 100% on where further I can look before splicing nodes out.
4 legs of 30 nodes (tm1809 nodes)
SSC V4 latest firmware (I've tested one version lower same results)
Distance to first node is about 14 inches
Picture of the setup. SSC is connected in the bottom right leg, goes up and then across to leg 2 at the top, goes down, goes across to leg 3 on the bottom goes up and across at the top to leg 4 and down. I've marked in red the connections.
So when all 4 are connected I'm seeing strange results on leg 3 one the 7th node up. Video to show
You are not allowed to view links.
Register or
LoginSo I move the SSC over to leg 2 (connection at the top) and test again. Entire string looks ok
You are not allowed to view links.
Register or
LoginMove the SSC over again to leg 3 (connection at the bottom) and test again. Entire string looks ok
You are not allowed to view links.
Register or
LoginNot sure where to splice since it works when I remove the first leg and I'm not seeing anything strange on the first leg.
Thoughts?
--Todd