DiyLightAnimation

Hardware => Lynx EtherDongle => Topic started by: tbone321 on July 22, 2013,

Title: Case Cutouts.
Post by: tbone321 on July 22, 2013,

I can see that in the EtherDongle coop, people are starting to ask for a seperate coop for cases that are already cut out for the Conductor.  While this may be a good idea for many, how about also posting a scale cutout template for those of us that already have cases.  This is DIY and I have no issue cutting the case if I know exactly where to cut it.  If it can be worked out for precut cases for this or future coops, that is great for people ordering new units but there are many of us with existing cases that simply need to be modified.

Title: Re: Case Cutouts.
Post by: rrowan on July 22, 2013,

This was already posted about 10 posts below this one.

http://diylightanimation.com/index.php?topic=11579.0

I did some measurements and drew it up in AutoCad but nobody replied back if they checked it with their cases and cutouts.

Its also in the Wiki equipment page Conductor section ETD Case Cut out
http://www.diylightanimation.com/wiki/index.php?title=Equipment#EtherDongle_and_Add_on_boards

Rick R.

Title: Re: Case Cutouts.
Post by: tbone321 on July 22, 2013,

Thanks Rick.  I have been away for a while and must have missed this.

Title: Re: Case Cutouts.
Post by: aich75013 on July 23, 2013,

Does the Slave use the same cutouts as the Conductor (minus the audio cutout)?

Title: Re: Case Cutouts.
Post by: tbone321 on July 23, 2013,

Yes.