RJ,
I want to confirm the diode orientation, on the video you say “the line needs to go to the right, towards the side that isn’t perfectly square off”, but the side that is not square is on the left on the diagram and the PCB on the video is in almost in vertical position, I can’t see very well but looks like the line is on the left when you put the diode on the PCB.
Can you confirm the diode orientation?
Thanks,
Cas.
Thanks for the quick reply.
Something I noticed is that the paste is too thick at first and was difficult to make it stick to the copper, until I did the second or third pad where the paste became oily and liquid, same happened when I switched the needle, the first line on the U2 was difficult then the paste became liquid again, looks like when the needle is used for first time it take the “lubricant” from the paste for a little bit. So I would recommend every time using a needle for the first time just discard the first 4 or 5mm of paste.
That is my experience so far, and so far has not been difficult at all, this is awesome :)
Cas.