DiyLightAnimation
Hardware => Lynx Wireless DMX => Topic started by: solidmodeler on January 08, 2010,
-
Will the "Express Wireless Receivers" from 2009 coop be fully compatible with the new Version 2 transmitters? I have 5 PCB’s which I have not bought parts for yet and thought I would get a jump on them while waiting for new LE coop to be completed. No big deal to wait till after Ver 2 beta testing and changes.
Thanks
Michael
-
I think this provides the answers you are looking for: http://diylightanimation.com/index.php?topic=2413.msg23484#msg23484 (http://diylightanimation.com/index.php?topic=2413.msg23484#msg23484)
As RJ as stated, the plan is for Version 2 to be fully compatible with Version 1. However, none of the Version 1 boards will work with the transceiver being used on the Version 2 - the transceiver has a different footprint.
You can fully populate the version 1 and have confidence you can use a mixture of version 1 and Version 2 units.
If you need the signal to carry a significant distance.... say more than 300 feet, you may want to use the Version 2 transmitter because of the increased strength of the module being used in version 2.
Larry
-
I saw where he covered the transmitter and standalone receiver. But not much about the Express receiver. I'll just wait and see what happens down the road.
Thanks,
-
The plan is to add two LED's to it for power and data recieved from the TX.
RJ
-
...However, none of the Version 1 boards will work with the transceiver being used on the Version 2 - the transceiver has a different footprint....
Larry
Huh?
-
...However, none of the Version 1 boards will work with the transceiver being used on the Version 2 - the transceiver has a different footprint....
Larry
Huh?
I'm pretty sure he's saying that one of the components being specified for Version 2 won't fit on the Version 1 boards... That is, some of the parts aren't interchangeable. But you can still build v1 boards with the old parts list & they'll work fine in networks with v2 boards.
--Dave
-
I think I caused some confusion here. There are 2 types of wireless receivers. One that is standalone that uses the same board as the transmitter referenced here http://diylightanimation.com/wiki/index.php?title=Image:Lynx_Receiver.JPG (http://diylightanimation.com/wiki/index.php?title=Image:Lynx_Receiver.JPG) and another smaller one that inserts into the LE referenced here http://diylightanimation.com/wiki/index.php?title=Image:Exrx.jpg (http://diylightanimation.com/wiki/index.php?title=Image:Exrx.jpg). The later is what I was refering to
I understood what you are saying RJ, same board as ver. 1.2 just upgraded with the addition of 2 LEDS, 1 for power and 1 for data.
Thanks much,