I built my EtherDongle and so far had had no success in getting it to work. You can see from my post here what I have tried so far:
You are not allowed to view links.
Register or
Login (about halfway down the page)
To Recap: I have been able to program the PIC, I am getting the correct voltage out of the 3.3 and 5 volt regulators I am not getting the green or MAG jack LED's to light when connected to my ethernet router (or directly to my computer). I have retouched all solder points on the board and there does not appear to be any bridges on my SMD devices. I am beggining to think the ethernet SMD chip is bad. Is there any way I can check for sure whether that is the problem?