DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: dearvbguru on November 05, 2012,

Title: Missing Step In Conductor Assembly Manual?
Post by: dearvbguru on November 05, 2012,

I just built my first conductor and think theres a step thats missing in the manual. 

When installing the double headers at the end, there is also a small two pin header on the opposite side of the board that is part of the kit and needs to be installed to plug into the board as well?

If you look closely at the pictures you can see it plugging into the mate socket on the etherdongle but I did not see it mentioned or highlighted in the instructions.

My kit also had the two pin socket but so did my ehtrdongles so assuming this is an extra part left over?

Title: Re: Missing Step In Conductor Assembly Manual?
Post by: rrowan on November 05, 2012,

Yeah I just saw the same thing

Install the two pin header to connect to the pwr header on the etherDongle.

I really don't know what the other part is for.

Rick R.