DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: animal on April 15, 2013,
-
Hi all,
I just need some basic dimensions of the MR16 Width and Height of the PCB.
Thanks,
animal :)
-
I will measure when I get home but I managed to mount one and Ray's 350w PS inside a CG1500 if the that's the direction you're heading. It's actually a bit smaller than you'd expect.
-
Exsaaaaaaaactly!!!!!!!. You got a picture. ;D
animal
-
I have at home. I even managed to get the pcb holes to line up with some bosses too.
-
4.25"x 4.75"x 1.25"
-
Your my Hero!!!! <res.
<la..
Yea that's the way I'm going to go with my mini trees this year. The MR16 will give me some head room.
Thanks, I appreciate it,
animal
-
Ray's 27 channel controller also fits as well. I am undecided exactly which way I am going but my minis will rgb this year too. If I do use the MR16 I will probably solder the disconnects to the board bypassing spade lugs as I have no love for the spade disconnects.
-
Just showing off now... ;D Ray's 27 channel controller fits boss holes too.
Probably will desolder xlr dmx connectors and solder pigtails to correct pads. There might even be enough clearance to fit pigtails between board and case.
-
You can actually just solder onto the j pads right above and not have to touch the xlrs