Hi everyone,
I'm having issues with my MR16.
I've run the address utility a dozen times but I'm not sure if it actually did anything or not. How do you tell? After addressing the board (starting channel 1) and then running Vixen, nothing happens and all channels appear on all the time. I followed the instructions in the other thread about disconnecting negative power lead first after programming but it made no difference.
I have flashed and re-flashed the PIC and got the correct checksum both times.
I'm also using a new dongle so it could also be that is not functioning correctly, although, the data light does flash on the dongle when Vixen is sending data.
I've got the data cable plugged into 'DMX In', terminate DMX jumper is set and mode is set to Operate. Red power light comes on, but green data lights never changes when Vixen sends data. The COM port settings are set to 115200 baud rate, parity none, stop bits 1, flow control none. Vixen is set to match the same.
What's the best way to attack this problem?
Thanks, Scott