DiyLightAnimation
Hardware => Lynx Express => Topic started by: DanHouston on September 04, 2012,
-
I just want to make sure I have this correct.....
I have an Etherdongle flashed with the DMX firmware, so it is outputting 4 universes (2048 channels) of DMX.
I have a combiner (in reverse) splitting the 4 universes out to 4 different CAT5 cables.
I have Vixen setup with 2048 channels and some test stuff using the EtherDongle plugin, also set for channels 1-2048.
I have 4 expresses all set to channel 1, each connected to a different port on the combiner (so each should be getting a different universe).
| Controller | Controller Start Channel | Combiner "Port" | Vixen Start Channel |
| Express #1 | 1 | 1 | 1 |
| Express #2 | 1 | 2 | 513 |
| Express #3 | 1 | 3 | 1025 |
| Express #4 | 1 | 4 | 1537 |
I think that is correct, but wanted to make sure (I'll be testing this tonight and will know for sure, but in case I was wrong wanted someone to set me straight). :)
So the table formatting was not what I expected:
Controller: Express #
Controller Start Channel: 1
Combiner "Port": 1
Vixen Start Channel: 1
Controller: Express #2
Controller Start Channel: 1
Combiner "Port": 2
Vixen Start Channel: 513
Controller: Express #3
Controller Start Channel: 1
Combiner "Port": 3
Vixen Start Channel: 1025
Controller: Express #4
Controller Start Channel: 1
Combiner "Port":4
Vixen Start Channel: 1537
-
Finished testing, and that is how it works.