DiyLightAnimation

Software => Vixen => Topic started by: ElectricCraft1 on June 09, 2009,

Title: output plugin error
Post by: ElectricCraft1 on June 09, 2009,

getting a router output error at end of my first sequence in my program. it ends the program and wont let me run anything else unless ui restart vixen.  already changed com ports.  any ideas

Title: Re: output plugin error
Post by: memphislights on June 09, 2009,

unchecked off DMX in the add-ins drop down menu?

also, what comm port are you using?

Title: Re: output plugin error
Post by: rrowan on June 09, 2009,

Hi EC

My first suggestion to try and I know you are going to think I am crazy or worse

Try Different USB Cables (I went through 4 cables before it worked well for me)

I would also try clicking on the menu bar
Tools
 Preference
  Sequence Execution
   (either Check or UnCheck) Reset Controller at the end of the Sequence

Rick R.

I forgot to say to check and see if you have the latest version of the FTDI drivers. The link to it is in the wiki software page at the bottom. If you do update MAKE sure you update both the com port and usb bus drivers included in the file on their site.

Title: Re: output plugin error
Post by: ElectricCraft1 on June 09, 2009,

unchecked and com 9, also tried com 10.  Ill try the suggestions.  Should I use the settings for the sequences or the program?

Title: Re: output plugin error
Post by: rrowan on June 09, 2009,

Wait

Are you just running a sequence in Vixen or are you running a Scheduled Program?

If the latter then you should flatten out the sequence. (No profile, no attached plugins)

Then use the profile setting for the program

Make sure the cross over is zero

Rick R.

Title: Re: output plugin error
Post by: ElectricCraft1 on June 10, 2009,

Cross over was the problem.  Thanks.  What is the purpose of this?

Title: Re: output plugin error
Post by: dmaccole on June 10, 2009,

The cross over is designed to fade one sequence into the next. It doesn't work and so must be set to zero.

\dmc