Hardware > Bobcat DMX Tester
Bobcat DMX tester won't do... Anything?
crazybob:
Hey all-
I finally got my tester assembled. Assembly went well, I've put together many expresses and never had a problem, so I figures this device shouldn't be much harder. No problems during assembly, and I'm due I did everything right. However, when I turn it on it does nothing. No number display lighting up. I checked battery polarity, everything looks good, including correct polarity to the board. I cant seem to figure it out. What's the best way to troubleshoot this?
I'm assuming the chips came pre-programmed in the coop, right?
bisquit476:
I don't know about the programing Bob, but there is special hex files for the tester, and the wireless xmitter, you may check that if you can,
Bill
rm357:
You need to load the firmware.
If I remember correctly my PICs were blank. If they weren't, they got erased and reprogrammed anyway...
Do you have a pickit? The pickit 2 will do, but if you have to buy one, you should get a pickit 3. The pickit 3 is required to program the etherdongle.
MrChristmas2000:
No
The PIC did not come programmed.
You have to have a PIC Kit 3 or equivalent programmer to program it.
Once it is programmed it will work like a champ.
I don't think any PICs are coming programmed anymore.
dlhoppe:
A PIC Kit 2 will work as well.
Navigation
[0] Message Index
[#] Next page
Go to full version