I just finished building 5 TX/RX and 2 EX/RX units. All TX/RX units work great! I am, however, having a strange issue with the EX/RX units.
With he units mounted to my Express(s), Plugging in the Express shows the unit to be receiving a DMX signal, but the lights do not chase (I'm using xLights chase feature to test).
Resetting the Express will not help.
The only way to get the channels working, is to pull off the EX/RX while the Express is powered up and then put it back in place. The channels fire up and work great.
I can then push the reset button and the whole unit will reset, but I must go through this disconnect/connect EX/RX again to get the channels to start flashing.
I am running an Express version 5, with the latest firmware installed on all devices. Wireless jumper is removed.
I have tested using wired, and it fires up just fine.
Any suggestions?