DiyLightAnimation
Hardware => Lynx Express => Topic started by: andytwo2 on October 09, 2012,
-
OK I have two lynx express. Cant get the second one to work. So what Ive done is reset the #2 expess to channels 1-16. Both express are set to channels 1-16. Then i have both express on the bench, both turned on and data coming from the computer (via Vixen and Enttic DMX open) Plug it in the #1 express and the leds do there thing and everything is fine. Unplug and plug in the #2 express. Nothing NO data light. Prelim tests are normal. Ive checked the solider joints on the back, all look good. Checked #2 against board #1 for parts placement and all looks good.
What to check now!!
John nickeldrr@yahoo.com
-
Hi Andy
As in your other posts, can you upload some photos of the board that is giving you troubles. If you can, then a photo of the front and back will help out a lot.
Steve (from Edmonton)
-
Hey everyone, I knew it would be simple and it was the jumper for the wireless was off. Everything is working fine.
One thing while im here: Ive been going to the upper left corner (in Vixen) clicking sequences, then open an exosting sequence. A window opens and shows the four sequences of mine. I click on one and then play it. Make changes etc what ever i want to do.
QUESTION is what do i click on to make the whole show play non stop.
I do have it set in the auto timmer calender but want to run test of whole show now.
TKS John <la.. <pop..
-
Good to hear that you got it working.
As I am at work and unable to use Vixen, if I recall you should be able to into the scheduler and run test. I will check later when I get home and I am sure others will assist prior to me getting home.
Have fun.
Steve (from Edmonton)
-
Thanks Steve. Leaving in the morning for Quebec City. Cruise up the St Larence seaway. Back on the 19th to set this up and see how it goes.
Thanks John
-
http://diylightanimation.com/index.php?topic=3577.0