Hey guys I'm having an issue getting my etherdongle to program the ssc's i'm incorporating into this years display. I have an etd with conductor attached flashed with pixelnet firmware, this is connected to an active hub that up til now has only been used for the dmx output. I have a laptop connected to the etherdongle and the output of the dongle to the pixelnet input on the active hub, then out of a port on the active hub to a v4 ssc. I have flashed the ssc with the v4 firmware and have the latest ssc utility running on the laptop. I noticed when i plug the ssc into the active hub some of the nodes flash on then off almost instantly. When I transmit the configuration to the ssc nothing is happening. The etd magjack is blinking in a manner that seems to indicate that it's working, i.e. yellow led blinking, but I'm not sure where I'm going wrong. When connecting to the etd what is the ip of the laptop supposed to set to? I have searched the boards but haven't been able to find it. I'm not sure how to trouble shoot my problem as I have no known good setup for pixelnet, only the dmx out of the active hub, any suggestions would be greatly appreciated.! Thanks.