DiyLightAnimation

Hardware => Lynx Smart String => Topic started by: PJNMCT on December 03, 2011,

Title: SmartString Hub with DMX Universe 5 and above do not work
Post by: PJNMCT on December 03, 2011,

I can get DMX universes 1-4 to work out of the smartstring hub but none above 4 on any of my hubs (tried 3). I'm obviously missing something.

Any thoughts?

-Paul

Title: Re: SmartString Hub with DMX Universe 5 and above do not work
Post by: jnealand on December 03, 2011,

You might try re=heating the solder joints on the selector pins and whatever the traces connect to.

Title: Re: SmartString Hub with DMX Universe 5 and above do not work
Post by: RJ on December 04, 2011,

Yes I have tested the firmware during the testing on all of them and it was working. Anyone else used the higher dmx settings?

Make sure the firmware is current but it likely is.

RJ

Title: Re: SmartString Hub with DMX Universe 5 and above do not work
Post by: dmoore on December 04, 2011,

Can you make a screencast-o-matic video of how you have your sequencing application setup?