After making sure your dongle works as RJ stated, you can make an adapter as I describe below.
I made my adapter using Keystone jacks (wired normally) to a rj45 wired for Renard.
Another way as suggested by budude on DIYC, cut a short pre-built cat5 cable in half and re-solder the wires.
DMX side -------- Renard side
Pin 1 ------------ pin 5
pin 2 ------------ pin 4
pin 7 ------------ pin 2
pin 8 ------------ pin 1
Make sure you label the ends for Renard and DMX.
I also attached a picture below for you on the DMX to Renard pin out.
Then all you need is a cheap cat5 inline coupler to connect it to your longer cat5 data line.
You are not allowed to view links.
Register or
LoginIn case your interested, this is how I got Lynx wireless EX/RX to connect to a Renard controller
You are not allowed to view links.
Register or
LoginLet me know if I can help with anything else.
Brian