I'm not very good at this kind of stuff yet, I can build the bored's but when it comes to making changes I get a little stuck and confused. I want to run some white leds of the MR16, the leds need 3.4V and 30ma. What resistor should I use? I just want to run one led per channel, I was wondering if someone could point me in the right direction of what resistor I should use. Also am I right in thinking the resistor will go in place of the 4.7K Current limiter resistor? And one last question, do I still install the resistors and caps that sit between the mosfets and chips? That's it I think.
Thanks Steve