It's a little hard to see due the limited surface area to print the silkscreen onto.Here is a pic that shows the pigtail being attached to the Aether.Looking at the back of the board from left to right:1. Ground (-)2. Power (+)3. Signal
You are not allowed to view links. Register or LoginIt's a little hard to see due the limited surface area to print the silkscreen onto.Here is a pic that shows the pigtail being attached to the Aether.Looking at the back of the board from left to right:1. Ground (-)2. Power (+)3. SignalHey Bill,Nice picture and great idea on the lexan. How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.Thanks,Roger
You are not allowed to view links. Register or LoginYou are not allowed to view links. Register or LoginIt's a little hard to see due the limited surface area to print the silkscreen onto.Here is a pic that shows the pigtail being attached to the Aether.Looking at the back of the board from left to right:1. Ground (-)2. Power (+)3. SignalHey Bill,Nice picture and great idea on the lexan. How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.Thanks,RogerHere you go... Pin 1 (top left pin) is emptyPin 2 (Signal Wire ) In this case white wire if using servo extensionsPin 3 (+5) Red wirePin 4 emptyPin 5 (Bottom left pin) groundPin 6,7,8 empty