Ok. I've got updated instructions for everyone, and also for Rick's revised manual.
I saw a couple bugs with the software, and with instructions the user can avoid some and work past others.
I also saw a situation where I tried to change the channel to 321-324, and I ended up with 510-512. (R,G,B... but no W)
Another oddity... before I set the channel, I found that only channels 1,2,3 were available as G,B,W (no R as it was likely an inaccessible 0)
Left/outer-most switch (SW2): Program Switch
Toggled left/outer: Program, Toggled Right/inner: Operate
Right/inner-most switch (SW1): DMX Termination
Toggled left/outer: Term Off, Toggled Right/inner: Term On
Here are the instructions:
1. Turn OFF power to AetherII
reset USB dongle
set DMX terminate (inner-most) switch to inner position (terminate on)
2. [While OFF] Verify that the outer-most switch it toggled to the inner position [Operate Mode]
3. [While OFF] Start the "Lynx Address Utility" as Administrator
4. [While OFF] Set COM port for dongle using Settings/Comport and the [Update] button
5. [While OFF] Change StartChannel number to XXXX
6. [While OFF] Select button "Program"
7. [While OFF] Flip outer-most switch to outer position [Program Mode]
8. Turn ON power to AetherII
9. [While ON] Wait for flashing red on AetherII
10. Turn OFF power to AetherII
11. [While OFF] Flip outer-most switch to inner position [Operate Mode]
12. [While OFF] Stop "Lynx Address Utility" (it may abort... don't worry about it)
13. [While OFF] Exit the utility.
14. Turn ON power to AetherII (if it lights up as blue, connection to the dongle was lost and the dongle should be reset...)
15. [Optional] Disconnect USB connection to Dongle
16. [Optional] Reconnect USB to Dongle
17. Test the device