DiyLightAnimation

Fun => The Porch => Topic started by: SteveMaris on November 17, 2011,

Title: IDMX help.
Post by: SteveMaris on November 17, 2011,

Hey,
I can't get my 2nd LOR pc board to respond.
I have the IDMX id set at 11. The first LOR PC board ID is set at 1. The first board works with no issues.
The second board is not responding. IT's ID is set at 17. IS that correct? I also have the 4 Lynx to hook up after the second LOR, but I can't get past this non responsive PC board. I know I have to swap the cat 5 cables going into the Lynx. Do the cables from board one(lor) to board 2 (lor) need to be swapped?
Helpppp meeee.
Thanks, Steve

Title: Re: IDMX help.
Post by: SteveMaris on November 17, 2011,

Ok so I just re-read Zmans DMX page and I see that the ID number on the second LOR must be 2. I will try it in the morning. My next question would be, going into the 1st Lynx board the ID must be set at the next channel number right?