Hello everyone. I got my active hubs in yesterday and they are all soldered up and ready to go
(thanks for the coop! one step closer). I already have a few SSC V2 and have also set them up with the pic3 (I know they work in test mode). question I have is the about the cable that goes from the active hub to the SSC as I don't have the RJ45 pigtails yet. I want to make sure I got it right. from the hub the RJ45 with the tab on top and starting from left to right i have pin
1) white/orange
2) orange
3) white/blue
4) blue
5) white/green
6) green
7) white/brown
8 ) brown
and on the SSC I have
white/orange = data 1
orange = data 2
white/blue,blue,white/green = power
green,white/brown,brown = ground
is this right?