« previous next »
Pages: [1]

Author Topic: LE Heat Sinks  (Read 1590 times)

Offline mmais68569

  • Sr. Member
  • ****
  • Posts: 374
LE Heat Sinks
« on: January 19, 2011, »
I am looking for a set of heat sinks for LE Ver.5 if you have an extra set or kno0w where I can get a set let me know.
         

      Thanks Mike
                               
Logged

Offline memphislights

  • Sr. Member
  • ****
  • Posts: 477
Re: LE Heat Sinks
« Reply #1 on: January 19, 2011, »
PM RJ, if he doesn't have any right now, he should have a some over after he finishes the LE coop.

I think that he is pretty busy right now, so give him a few days to respond.
Logged
It's not about more, it's about enough.

Offline Asterix0

  • Full Member
  • ***
  • Posts: 39
Re: LE Heat Sinks
« Reply #2 on: January 19, 2011, »
Me too!
Logged

Offline RJ

  • Administrator
  • Sr. Member
  • *****
  • Posts: 8519
Re: LE Heat Sinks
« Reply #3 on: January 19, 2011, »
I am out right now but will have them after the coop ships.

RJ
Logged
Innovation beats imitation - and it's more satisfying

Offline WWNF911

  • Patron Member
  • Sr. Member
  • ****
  • Posts: 1079
Re: LE Heat Sinks
« Reply #4 on: January 20, 2011, »
I have a couple extra black ones.
« Last Edit: January 20, 2011, by WWNF911 »
Logged
Leon

Offline CaptKirk

  • Sr. Member
  • ****
  • Posts: 244
Re: LE Heat Sinks
« Reply #5 on: January 20, 2011, »
I made my own out of a hunk of scrap extruded aluminum that was a bit too tall but was easily cut down to RJ's heat sync size.  Mine has the bend on the bottom to allow it to mount to the board (RJ- I used insulating washers on both the head side AND the spacer side against the board to prevent shorts) but is missing the top bend (or "handle" as RJ puts it in the assembly videos) and the laser etch.  Not bad for scrap and a Sawz-All cut job....
« Last Edit: January 31, 2011, by CaptKirk »
Logged
"Beam me up Scotty- there is no intelligent life on this planet."
Pages: [1]
« previous next »