DiyLightAnimation

Hardware => Lynx SSR4 => Topic started by: tthompson on November 20, 2012,

Title: Dim SSR4
Post by: tthompson on November 20, 2012,

I have my SSR4 built and all 4 channels are dim.

I am running through an etherdongle and the lights come on/off, but not in a timely manner.

I am using incandescent mini 50 count bulbs so there should be plenty of resistance.

I don't see an octocoupler and the triacs are all brand new in the latest kit.


any suggestions?

TimT.

Title: Re: Dim SSR4
Post by: chrisatpsu on November 20, 2012,

which version of the SSR4?

Title: Re: Dim SSR4
Post by: rrowan on November 20, 2012,

I would check all of the solder joints and reflow them just to be sure.

Rick R.

Title: Re: Dim SSR4
Post by: Ron on November 20, 2012,

What software are you using to test?  You might make sure that is working as expected first.

Title: Re: Dim SSR4
Post by: tthompson on November 21, 2012,

re-flowing did not do anything.

I tried another one as well with the same results.

I am using vixen to test via the etherdongle.

I will take another look at these again after I get the rest of my lights up. 

Always waiting till the last minute gets you every time.

TimT.

Title: Re: Dim SSR4
Post by: tbone321 on November 21, 2012,

Check and make sure that you didn't set a max output in Vixen.  I would try another software such as XLights to test them just to make sure.