DiyLightAnimation
Hardware => Lynx Express => Topic started by: bob81354 on December 02, 2012,
-
HI to all
I just finished my first LE and all i get is the 3.5 v & 5v and the #6 leds on
I think i programed my chip right but no go and all my sodering looks good
thanks Bob
-
Do you mean you get nothing when running from your computer or that you get nothing when running the built-in test mode on the board?
It could be the chip is not programmed right. Tell us more please.
Don't be discouraged, there are a bunch of great folks willing to help here and I am confident someone will get your problem fixed.
-
I would reflash the pic. What you are seeing is a normal reaction to the pic not properly programmed.
Rick R.
-
I had the exact same issue last night (among other Rookie mistakes!). Reflashing fixed up the ghost #6 LED...replacing a couple of burned out chips solved the other! Doh!
-
Just had this exact same scenario, I reflashed pic LE workin like a charm. ;D
-
Almost definately needs to be reflashed. I had this happen on my first few and before I read it here earlier this year I was pulling my hair out thinking I did something wrong. Good luck, you'll get it!
-
Almost definately needs to be reflashed. I had this happen on my first few and before I read it here earlier this year I was pulling my hair out thinking I did something wrong. Good luck, you'll get it!
+1