DiyLightAnimation

Hardware => Lynx SSR4 => Topic started by: paul58 on June 01, 2010,

Title: ssr4 start address
Post by: paul58 on June 01, 2010,

Hello, I just finished a couple of dmx ssr4's and i am unclear still after reading how to change the start address of one of them to ch 5 for example. I reflashed the pic just in case. Still no luck. Am i to understand that the lynx address utility will do this? If so is there a procedure i'm missing. Sorry to be of bother. Thanks Paul.

Title: Re: ssr4 start address
Post by: rrowan on June 01, 2010,

Hi Paul

No problem at all.

Start up the Lynx Utility program and select the correct com port.
Select the start address you want and click on the program button.

Turn on the SSR4
Count to 3
Move the blue jumper from opera mode to program mode
Turn off the SSR4
Move jumper back to opera side
Click the Stop button on the Lynx Utility

Turn SSR4 back on and see if the lights turn on with the correct channel


Hope that helps

Rick R.

Title: Re: ssr4 start address
Post by: paul58 on June 01, 2010,

Whew! Thanks so much. I have it now!!Paul.