I guess I need a bit of help...
Can someone point me to an explaination of the various Wireless options, and some commentary...
Unless I am correct, in which case maybe this will help those who are confused also...
Kit 1 – Version 2 Tx/Rx Parts Kit
Kit 2 – Version 2 Tx/Rx PCB
Kit 3 – Version 2 TX/RX Case
**************'
1, 2, & 3 are all needed to make a complete "device", Correct?
And this device can be used to transmit the data from either a USB Dongle or from an express to another receiver...
This device can also be switched to RECEIVE and drive a chain of Express controllers,
This device can not attach directly to the Header Pins on an Express...
and is the most versitle, because it can do both... but not mountable directly to the Express Header...
**************'
Kit 4 – Version 2 LE/RX Parts Kit (Lynx Express Receiver)
Kit 5 – Version 2 LE/RX PCB
***************
4 & 5 are both needed to make a complete "device", correct?
This is a RECEIVE only "module" that attaches directly to an Express receiver...
It can drive a single express, or that express can be chained to others..which are driven by its receive signal...
Without Kit 6, below, it has no other function but to mount on an Express and RECEIVE...
***************
Kit 6 – LE/RX Header Pin (Allows LE/RX to be used with other Lynx gear like the MR16 Controller, SSR4…etc…)
***************
Self Explanitory...
***************
So,
Am I confused?
Please clairfy any misconceptions I may have,
Thanks