DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: ponddude on August 14, 2010,

Title: Version 2 cases
Post by: ponddude on August 14, 2010,

Out of curiosity, do the Version 2 cases have holes for the LEDs?  Why?  Well I was soldering up my TX/RX's and didn't know if I should mount the LEDs flat on the board or leave them up so I can bend them.

Just wondering ???

Title: Re: Version 2 cases
Post by: wbuehler on August 14, 2010,

You are not allowed to view links. Register or Login

Out of curiosity, do the Version 2 cases have holes for the LEDs?  Why?  Well I was soldering up my TX/RX's and didn't know if I should mount the LEDs flat on the board or leave them up so I can bend them.

Just wondering ???

Leave them up a bit so they can be bent over, the version 2 cases will have two holes for the LED's

Bill

Title: Re: Version 2 cases
Post by: ponddude on August 14, 2010,

Thanks Bill...I figured as much