DiyLightAnimation
Hardware => Lynx SSR4 => Topic started by: pHoZfoRus on October 03, 2011,
-
I am not sure if I am reading it right, but the equipment page on the wiki states that the SSR4-DMX is not 240v compatible (dimmable). On the Lynx Voltage info page in the wiki, it states that the SSR4-DMX is 240v compatible with a 240v transformer and different resistors required.
I have read through most of the SSR posts and have noted that there may or may not be firmware for 50hz. As I do not have a Freestyler, the Appendix A voltage modification does not appear to be for me.
Will it be similar to the substitution that was required in the Lynx Splitter (Digi-Key Part Number 567-1019-ND)?
Can someone please point me in the right direction to identify the correct parts that need substitution and/or if this will be possible if the firmware is not available?
Russell
-
Hi Russell
As far as I know there is no firmware for us folks downunder on 50Hz supply, I have a few made up ready to go when (hopefully) it will show up.
http://diylightanimation.com/index.php?topic=3029.0
Kev :-)
-
Thanks Kev - it looks like I might go down the same path.
Did you end up substituting the transformer? I am tempted to go ahead and order the same as I did for the splitter as the power traces look to match pending any other advice that may turn up.
Russell
-
I haven't done anything about the transformer as yet, what were you looking at?
Kev :-)