DiyLightAnimation
Hardware => Lynx Express => Topic started by: shgshgshgshg on July 22, 2012,
-
Hey everyone,
I'm having some problems with one of my expresses. At first glance It appears to be the same issue as in the other thread I posted about earlier (http://diylightanimation.com/index.php?topic=8833.0).
I have just checked the 2700PF and it is not touching the PCB. I have also checked the voltage against pins 27 and 28 on the PIC and it appears to be about 7 volts. My understanding is that this should be about 3.3.
Other info:
3.3 and 5v lights are both on. All of the chips look correct. Channel 16 light comes on when I press the select button...
Thanks,
Stephen G.
-
More info:
I attempted to put a working pic in the broken express and it did not have any change. I put the PIC from the broken express in a working express and it did not work. So I know the PIC needs to be re-flashed.
Also with no PIC in place on the broken express it is only showing the 3.3 volt light not the 5 volt light.
-
With a bright light and a good magnifying glass, I would check every soldering joint
Rick R.