DiyLightAnimation
Hardware => Lynx Aether => Topic started by: inzeos on November 12, 2011,
-
What size hole should be drilled to mount the heatsink into contact w/ the case? Is it intended to use the short stubby sheet metal screws to connect them? May seem obvious; however, it is not in the manual yet.
-
The short stubby screws seemed too short... especially since the heat sink was frabricated with a thicker material than RJ spec'd.
So, I found another machine screw and a drill bit that was the size of the shank but smaller than the thread. I drilled through the casing and the heat sink. I only used one screw to fasten it together... but use more if you are inclined.
-
i used the short stubby ones. it does say the size somewhere in there. The short stubby ones just barley made it through the heatsink, but they made it.
-
Thats the way it is suppost to be so you do not have points sticking out in to the housing to hurt yourself on.
RJ