DiyLightAnimation
Hardware => Lynx Express => Topic started by: wrxin on October 31, 2011,
-
This is my first lynx express. Just finished the assembly. The two LEDS (5 and 3.3) light up fine but I have a dimly lit number six LED and the display does not work. Pressing and holding reset turns off the number six LED but it dimly lights again when I release the button.
I have not programmed the chip yet.
I'd really appreciate any help.
Thanks
-
Greetings,,,
That should change for the better after you program the chip.
Keith
-
make sure you look at your solder joint where the led are dim .. i had the same problem on 1 led ans i guess i had cold fusion as i re heat the defect joint and voila everything work flawless ... as i was told yesterday ... the chip were program by RJ so i don't think it is the chip program ...
-
Thanks for the help. I'll program the PIC and see how it goes.