DiyLightAnimation

Hardware => Lynx Smart String => Topic started by: lightsup on October 16, 2013,

Title: DSC programming
Post by: lightsup on October 16, 2013,

Hi can the DSC start address be programme with the dmx dongle. I have been trying for the last hour with Smart String Controller Configuration with no result its transmitting but don't seem to programme the start add. is there a FAQ on the SSC configuration software. here the settings on the Smart String Controller Configuration . start channel 1. usb dongle selected. 3 channel string. forward selected by default. node count 1. null mode 0 . string selected. click on transmit. now how long do you wait till it stops or do a manual stop. the DSC is set to program with 12 volt on. Please HELP.

Title: Re: DSC programming
Post by: jnealand on October 16, 2013,

You can use the USB dongle flashed with pixelnet firmware.  The USB dongle flashed with DMX firmware will not work.

Title: Re: DSC programming
Post by: lightsup on October 16, 2013,

well I flash the dongle with the pixelnet, got it to program but its not responding with RJ dmx deck or vixen. I am done for tonight. Thanks for the help jnealand I got one step forward, I will try again tomorrow. good night.

Title: Re: DSC programming
Post by: lightsup on October 17, 2013,

Thanks Jim it works . :)