DiyLightAnimation
Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
Home
Wiki
Blog
Chat
Help
Login
Register
DiyLightAnimation
»
Hardware
»
Lynx Express
»
Problem with new lynx express
« previous
next »
Print
Pages: [
1
]
Author
Topic: Problem with new lynx express (Read 1175 times)
wrxin
Jr. Member
Posts: 20
Problem with new lynx express
«
on:
October 31, 2011, »
This is my first lynx express. Just finished the assembly. The two LEDS (5 and 3.3) light up fine but I have a dimly lit number six LED and the display does not work. Pressing and holding reset turns off the number six LED but it dimly lights again when I release the button.
I have not programmed the chip yet.
I'd really appreciate any help.
Thanks
Logged
KeithTarpley
Administrator
Sr. Member
Posts: 1990
Re: Problem with new lynx express
«
Reply #1 on:
October 31, 2011, »
Greetings,,,
That should change for the better after you program the chip.
Keith
Logged
"Now I know the only foe is time." -Moody Blues
barbotte
Sr. Member
Posts: 242
Re: Problem with new lynx express
«
Reply #2 on:
October 31, 2011, »
make sure you look at your solder joint where the led are dim .. i had the same problem on 1 led ans i guess i had cold fusion as i re heat the defect joint and voila everything work flawless ... as i was told yesterday ... the chip were program by RJ so i don't think it is the chip program ...
Logged
wrxin
Jr. Member
Posts: 20
Re: Problem with new lynx express
«
Reply #3 on:
October 31, 2011, »
Thanks for the help. I'll program the PIC and see how it goes.
Logged
Print
Pages: [
1
]
« previous
next »
DiyLightAnimation
»
Hardware
»
Lynx Express
»
Problem with new lynx express