DiyLightAnimation
Hardware => Lynx Express => Topic started by: Brad on November 01, 2009,
-
I had a little time yesterday before the Trick or Treaters started to flood the streets. Decided to run the 1st test on LE #2, Ver 4. Plugged all chl's into mini lights, had Vixen ready when it happened. Applied power to the PCB and...."poof"....then nothing. ??? :'( :'(
Will remove it from the enclosure this morning and figure out what, and more important, why it happened.
Stay tuned. I'm sure I'll have questions.
Brad
-
I had a little time yesterday before the Trick or Treaters started to flood the streets. Decided to run the 1st test on LE #2, Ver 4. Plugged all chl's into mini lights, had Vixen ready when it happened. Applied power to the PCB and...."poof"....then nothing. ??? :'( :'(
Will remove it from the enclosure this morning and figure out what, and more important, why it happened.
Stay tuned. I'm sure I'll have questions.
Brad
Man that sucks! I was just gonna contact you to see if you wanted to flash some PICs. (Was a little busy yesterday)
I'll give you a call.
Having nightmares about running out of time and hoping the LE gremlins can't find their way to my house.
Leon
-
Thanks Leon. This must be my lucky day ;D ;D
I should run down and lay a hundred on the Pass Line at the Nugget 8) ;D
Started to really get worried when under bright light I could see no burnt components. That should be good news. But I could not identify what caused the "phttt" when plugged in yesterday.
Figured I'd check the pic. Did not look properly seated. Pulled it out re-seated it, plugged it in....and.....I HAVE BLINKING LIGHTS ;D ;D
So lucky not to have fried something.
Brad
-
Lucky you Brad!
John